Losi LOSB0289 Drift R Manual - Manual (Page 21)

30
95
27
BAG E (Continued)
18
Figure 40
Figure 41
Figure 40
Figure 41
!
Step 4. Thread a short head ball stud (68) on each side of the
shock tower into the closest hole to the middle of the lowest set of
holes.
!
Step 5. Insert a 4-40 x 7/8" cap head screw (66) one on either side
of the shock tower (95) -in the upper set of four holes, into the second
hole out from the middle. Secure the screws (66) to the tower (95) by
threading a 4-40 zinc nut (67) over each screw (66) and tightening.
The screws should extend away from the recessed area in the
rear tower and face towards the back of the chassis.
!
Step 6. Install the rear body mounts (96) by interlocking the post
on the body mount (96) with the blind hole in the shock tower (95)
and lining up the through holes. Secure the body mounts (96) by
threading a 4-40 x 3/8" flat head screw (31) through the body mount
(96) into the rear shock tower (95) as indicated in Figure 40.
31 66 67 68
!
Step 7. Attach the rear shock tower (95) to the rear of the chassis
(27) with four 4-40 x 3/8" cap head screws (30). The screws (30) thread
into the top-most and bottom-most holes surrounding the posts, which
stick out of the rear of the chassis (27). The shock tower (95) should
interlock with the posts on the chassis (27).
There is a short thread-cutting screw included in the wrench
bag. This screw can be used to tap threads in the holes in the main
chassis. Pre-tapping these holes makes it easier to install the screws
during assembly.
30
66
68
95
67
31
96