Losi LOSB0289 Drift R Manual - Manual (Page 2)

Welcome XXX-S Sport Owner!
Thank you for selecting the XXX-S Sport for your new R/C model. As you will see, we have made every effort to design
and produce a sedan that is not only most competitve, but also easy to maintain. Before you do any disassembly or mainte-
nance, please take a few moments to read through the following instructions. This will familiarize you with the various parts and
assemblies as well as the tools you will need. Taking an extra moment before starting can save you a good deal of time and
assure proper assembly.
Once again, thank you for choosing the XXX-S Sport.
Team Losi
1. INTRODUCTION
XXX-S SPORT DIMENSIONS
Overall Length: 16-5/8" Front Width: 7-7/16" Rear Width: 7-15/32" Height: 4-3/4"
Wheelbase: 10-1/8" All dimensions at ride height. Weight will vary depending on accessories.
Figure 1
i
NOTES & SYMBOLS USED
This is a common figure number found at the beginning of each
new illustration throughout the manual.
!
Step 1. Each step throughout the entire manual has a check box
to the left of it. As you complete each step, mark the box with a check.
If you need to take a break and return to building at a later time you
will be able to locate the exact step where you left off.
This is a common note. It is used to call attention to specific
details of a certain step in the assembly.
IMPORTANT NOTE: Even if you are familiar with Team
Losi kits, be sure and pay attention to these notes. They point out
very important details during the assembly process. Do not ignore
these notes!
In illustrations where it is important to note which
direction parts are facing, a helmet like this one will be included in the
illustration. The helmet will always face the front of the car. Any
reference to the right of left side will relate to the direction of the
helmet.
It is helpful to read through the instructions for an entire bag
prior to beginning service or disassembly. Key numbers (in paren-
thesis) have been assigned to each part and remain the same
thoughout the manual. In some illustrations, parts which have al-
ready been installed are not shown so that the current steps can be
illustrated more clearly.
For your convenience, an actual-size hardware identification
guide is included with each step. To check a part, hold it against the
silhouette until the correct part is identified. In some cases extra
hardware has been supplied for parts that may be easy to lose.
The molded parts in the XXX-S Sport are manufactured so that
they interlock. When screws are tightened to the point of being
snug, the parts are held firmly in place. For this reason it is very
important that screws not be overtightened in any of the plastic parts.
To ensure that parts are not lost during construction, it is recom-
mended that you work over a towel or mat to prevent parts from
rolling away.
1. Select an area for assembly that is away from the reach of small
children. Some parts in this kit are small and can be swallowed by
children, causing choking and possible internal injury.
2. The shock fluid and greases supplied should be kept out of
childrens' reach. They are not intended for human consumption!
3. Exercise care when using any hand tools, sharp instruments,
or power tools during construction.
4. Carefully read all manufacturers' warnings and cautions for
any glues, chemicals, or paints that may be used for assembly and
operating purposes. When you are using glues, chemicals, and paints
you should always wear eye protection and a mask. KIT/MANUAL ORGANIZATION
IMPORTANT SAFETY NOTES