Losi LOSB0289 Drift R Manual - Manual (Page 23)

58
68
85
83
58
81 82
101
92
BAG E (Continued)
20
Figure 45
Figure 45
Figure 46
Figure 46
Figure 47
Figure 47
Figure 46A
!
Step 15. Attach the rear hub assembly to the rear arm (92) by
aligning the holes in the rear hub (101) with the holes in the rear arm
(92). Insert a 3/32" x .930" hinge pin (81) through the arm (92) into the
hub (101) as indicated in Figure 45.
!
Step 16. Make sure the hinge pin (81) is centered between the
ends of the arm (92). Secure the hinge pin (81) by threading a 5-40 x
1/8" set screw (82) into the outside of the rear hub (101).
!
Step 17. Repeat Steps 15-16 for the remaining rear hub assembly.
81 82
!
Step 18. Thread a plastic rod end onto each end of a 1.375"
turnbuckle (83). Tighten both rod ends (58) equally until the rod is the
same length as the rod in Figure 46A. Make two of these tie rod
assemblies.
Each end of the turnbuckle is threaded opposite. The end
closest to the square shoulder has right-hand threads, the other has
left-hand threads. This allows the length of the rods, once installed,
to be adjusted without removing them.
58 83
!
Step 19. Place a "foam thing" (85) over the ball stud (68) in the
rear hub (101). Place a second "foam thing" (85) over the ball stud in
the rear shock tower (95).
!
Step 20. Snap the end closest to the shoulder of the turnbuckle
assembly to the ball stud in the left rear hub (101). Snap the other end
to the ball stud (68) in the rear shock tower (95). Repeat Steps 19-20 to
attach the other tunbuckle assembly to the right rear arm (92)
assembly.
Assure that the shoulder of the turnbuckle is located towards
the outside of the chassis for easier adjustment later.