Losi LOSB0289 Drift R Manual - Manual (Page 19)

84
58
58
69
85
68
80
41
58
43
70
BAG D (Continued)
16
Figure 35
Figure 35
Figure 36
Figure 36
Figure 37
Figure 37
Figure 36A
!
Step 24. Place a "foam thing" (85) over the ball stud (68) located
in the top of the spindle carrier (80). Place a second "foam thing" (85)
over the ball stud (68) located in the shocktower (69).
!
Step 25. Snap the end, closest to the shoulder, of the turnbuckle
assembly to the ball stud (68) in the spindle carrier (80). Snap the
other end to the ball stud (68) in the shock tower (69). Repeat Steps
24-25 to attach the other turnbuckle assembly to the right spindle
assembly.
Assure that the shoulder of the turnbuckle is located towards
the outside of the chassis for easier adjustment later.
!
Step 26. Thread a plastic rod end (58) onto each end of a 1.125"
turnbuckle (84). Tighten both rod ends (58) equally until the rod is the
same length as the assembled rod in Figure 36A. Make two of these
assemblies.
Each end of the turnbuckle is threaded opposite. The end
closest to the square shoulder has right-hand threads, the other has
left-hand threads. This allows the length of the rods, once installed,
to be adjusted without removing them.
58 84
!
Step 27. Snap the end, closest to the shoulder, of the turnbuckle
assembly to the ball stud (43) in the left spindle (70). Snap the other
end to the ball stud (43) in the left bellcrank (41). Attach the other
turnbuckle assembly to the right bellcrank (42) and the right spindle
(70).