Losi LOSB0289 Drift R Manual - Manual (Page 14)

53
48
43
57
58
55
27
31
BAG C (Continued)
Figure 23
Figure 23
Figure 24
Figure 25
Figure 24A
Figure 25
Figure 24
11
"
Step 18. Install the servo into the chassis (27) as shown in
Figure 23. The pins from both servo mounting posts (55), (56) should
fit into the holes and sit flat against the chassis (27).
"
Step 19. Secure the servo to the chassis (27) with two 4-40 x 3/8"
flat head screws (31).
31
"
Step 20. Thread a short plastic rod end (58) onto each end of the
4-40 x 5/8" threaded rod (57). Tighten both sides equally until the rod
is the same length as the one shown in Figure 24A.
58 57
"
Step 21. Attach the rod end (58) to the ball stud (43) in the servo
saver arm (53) and the other to the ball stud (43) in the drag link (48) as
indicated in Figure 25.
58
57