Losi LOSB0289 Drift R Manual - Manual (Page 18)

83
58
82
80
63
81
70
43
73
80
24
68
47
80
BAG D (Continued)
15
Figure 32
Figure 32B
Figure 33
Figure 33
Figure 34
Figure 34
Figure 32A
Figure 34A
!
Step 17. Insert two carrier/steering bushings (47) into the upper
and lower holes in the spindle carrier (80) from the inside as shown in
Figure 32A.
!
Step 18. Attach the spindle (70) to the spindle carrier (80) by
sliding the CVD dogbone (73) through the spindle carrier (80) as
illustrated in Figure 32B. Line up the holes in the spindle (70) and the
spindle carrier (80). Thread a short head ball stud (68) through the
carrier bushing (47) into the spindle (70) from the top of the spindle
carrier (80). Thread a 4-40 x 5/16" button head screw (24) through the
carrier bushing (47) into the spindle (70) from the bottom of the spindle
carrier (80).
!
Step 19. Repeat Steps 17-18 for the right spindle and carrier
assembly.
24 47 68
81 82
!
Step 20. Attach the left spindle and carrier assembly to the left
front arm (63) by aligning the holes in the spindle carrier (80) with the
holes in the front arm (63). Insert a 3/32" x .930" hinge pin (81) through
the arm (63) and the spindle carrier (80).
!
Step 21. Make sure the hinge pin (81) is centered between the
ends of the arm. Secure the hinge pin (81) by threading a 5-40 x 1/8"
(82) set screw into the bottom of the spindle carrier (80).
!
Step 22. Repeat Steps 20-21 for the right arm assembly
!
Step 23. Thread a plastic rod end (58) onto each end of a 1.375"
turnbuckle (83). Tighten both rod ends (58) equally until the rod is the
same length as the rod in Figure 34A. Make two of these tie rod
assemblies.
Each end of the turnbuckle is threaded opposite. The end
closest to the square shoulder has right-hand threads, the other has
left-hand threads. This allows the length of the rods, once installed,
to be adjusted without removing them.
58 83