Losi LOSB0289 Drift R Manual - Manual (Page 16)

30
69
27
68
66
67
69
BAG D (Continued)
13
Figure 28
Figure 29
Figure 28
Figure 29
!
Step 4. Insert a 4-40 x 7/8" cap head screw (66) on either side of
the shock tower (69) through the second hole out from the middle on
the top of the shock tower (69). Secure the screws (66) to the tower
(69) by threading a 4-40 zinc nut (67) over each screw (66) and tight-
ening.
The screws should extend away from the recessed area in the
front shock tower.
!
Step 5. Thread a short head ball stud (68) into the second hole
out on the lower four holes on either side of the shock tower (69).
66 67 68
!
Step 6. Attach the front shock tower (69) to the front of the
chassis (27) with four 4-40 x 3/8" cap head screws (30). The screws
(30) thread into the top-most and bottom-most holes, surrounding
the posts, which stick out of the front of the chassis (27). The shock
tower (69) should interlock with the posts on the chassis (27).
There is a short thread-cutting screw included in the wrench
bag. This screw can be used to tap threads in the holes in the main
chassis. Pre-tapping these holes makes it easier to install the screws
during assembly.
30