Losi LOSB0289 Drift R Manual - Manual (Page 33)

Before installing the body to the chassis use scotch tape or
strapping tape and run a piece from the inside of the body over the
body mount holes. Use a hobby knife or round file to open the hole
back up. This will ensure your paint does not become rubbed off.
BAG H (Continued)
30
Figure 65
Figure 65
Figure 66
Figure 66
!
Step 27. Trim the body (149) and wing along the trim lines as
shown.
!
Step 28. Once the perimeter of the body is cut, line the body up
with the tires. Front to back and right to left. Make four 3/16" diam-
eter holes in the areas where the body mounts are touching and
another where the antenna will come through. There should be dimples
in the body to help guide you.
38
121
37
149
!
Step 29. Make four 1/8" diameter holes: Two in the areas on the
wing (149) that are marked with three dimples; and two in the areas
marked with dimples on the wing mount stand-offs at the rear of the
body. Use the middle holes for mounting in the wing.
!
Step 30. Align the holes in the rear wing (149) with the holes in
the wing mount stand-offs at the rear of the body. Slide a #4 washer
(37) over each of the two 4-40 x 1/4" button head screws (38). Insert
the 4-40 x 1/4" button head screw (38) with washer, down through the
wing, and through each of the holes in the body.
!
Step 31. Secure the wing to the body by threading a 4-40 locknut
(121) onto each of the two screws (38).
!
Step 32. Attach the body (149) to the rolling chassis and secure
the body with four body clips (97): Two through the front body
mount posts; and two through the rear body mounts.
38 37
121 97