Losi LOSB0289 Drift R Manual - Manual (Page 15)

59
63
62 61
29
65
151
59
27
31
1 2
Figure 26
Figure 27
!
Step 1. Install the front left inner pivot block (59) by threading
two 4-40 x 3/8" flat head screws (31) through the bottom of the
chassis (27) into the pivot block (59) as indicated in Figure 26. Repeat
for the right front inner pivot block (60).
The left & right inner pivots are marked with "L" & "R".
Figure 27
Figure 26
!
Step 2. Slide an 1/8" inner hinge pin (62) through the larger holes
of each of the two front arms (63).
!
Step 3. Position the arm (63) so that the shock mount hole faces
the front of the chassis (27). Slide a .060" spacer (61) over each side of
the pin as indicated in Figure 27. Insert the arm (63) into the inner
front pivot block (59), (60). Capture the front arms (63) by placing the
front main block (65) marked with "2F" onto the inner hinge pins (62)
as shown in the illustration in Figure 27A. Secure the front main block
(65) by threading two 4-40 x 1/2" flat head screws (151) through the
main block (65) into the upper holes in the front diff cover (29).
Before you tighten the main block it may be necessary to slightly
loosen the screws in the inner pivots about 1 full turn. Once this is
done, tighten the main block, followed by tightening the inner
pivots. This will ensure you get the correct pin angle in the arms.
1 62
Figure 27A
BAG D
ASSEMBLE MAIN BLOCK
IN THIS DIRECTION
151
31