Mercedes-Benz CL-Class 2008 COMAND Manual - Manual (Page 195)

194
Control systems
COMAND navigation (introduction)
Setting POI symbols
You can set which points of interest (POIs)
should be displayed as symbols in the
map. POIs are garages, hotels, movie the-
aters or restaurants, for example.
The following settings are possible:
ț “Standard symbols” (symbol deter-
mined by the factory settings)
ț “Personal symbols” (you can determine
the symbols yourself)
ț “No symbols”
̈ Adjusting: Select “Navi” Ǟ “Navi” Ǟ
“Map Display”.
The map display list appears. A dot R
indicates the current setting.
̈ Select “Standard symbols”, “Personal
symbols” or “No symbols”.
If you select “Personal symbols”, the
list of POIs appears.
̈ Switching POI symbol display on
or off: Select the desired POI.
The corresponding symbol displays
are switched on or off, depending
on the previous status. A check-
mark indicates which status is ac-
tive. You can switch on the symbol
displays for more than one POI.
̈ Exiting menu: Slide o m p or press
back button L in the center console
( ୴ page 84).
Arrival time and distance
You can set whether the estimated arrival
time and the distance to the destination
should be displayed in the map.
̈ Displaying: Select “Navi” Ǟ “Navi” Ǟ
“Map Display”.
The map display list appears. A dot R
indicates the current setting.
̈ Select “Arrival Time/Distance”.
Depending on the previous status the
display showing the arrival time and
distance is switched on or off.
i Depending on the map scale on the map,
POI symbols may not be visible on the map al-
though their display is activated. In addition, POI
symbols may be covered by the map’s labels.
i The list shows all symbols that are contained
in the digital map across all states (USA) and/or
provinces (CDN). Not all POIs in all states (USA)
or in all provinces (CDN) are available, however.
Certain POI symbols may not be displayed on the
map, even if the symbol display is switched on.