SINGER CE-100 Futura - Manual (Page 76)

76
USB cable
Câble USB
Cable USB
CD
Insert
Insertion
Etiqueta del estuche
2
1
FUTURA embroidery is a "system" of the machine
and the software providing powerful options and
capabilities. In order to install the software, please
look into the CD insert for further information.
Power/light switch “ON”
Interruptor corriente/luz “ON”
Interrupteur moteur/lumière “ON”
PREPARING THE MACHINE BEFORE
INSTALLING THE HOOP
1. Turn hand wheel toward you until needle comes to its highest
position.
2. Connect your PC to the FUTURA sewing machine with USB
cable.
3. Turn on power to machine. (Refer to page 10 - 12.)
NOTE: If the USB cable is unconnected, an error message
“PC” will be displayed on the control panel.
The carriage of the embroidery unit will move automatically
to the embroidering standby position.
(If the sewing machine needle is not close to its highest
position, the Start/Stop switch will flash and the carriage will
not move.)
4. Insert the software CD into the CD-ROM disc receiver in your
PC.