CANOGA PERKINS 9145E Network Interface Device Software Version 2.1 - Manual (Page 49)

Diagnostics 9145E NID Software User’s Manual
VLAN Loopback
41
Figure 4-6 VLAN Loopback
To configure 802.1ag Loopback, type 1 and press Enter. The 802.1ag Loopback Configuration screen
(Figure 4-6) opens.
Figure 4-7 802.1ag Loopback Configuration
Administration State - To enable or disable the loopback responder, type 1 and press Enter. Cycle
between Enable and Disable. Press Enter to confirm the setting.
VLAN ID - This is the VLAN ID to match for responding to LBMs (Loopback Messages initiated by
another agent).
To enter a VLAN ID or a range, type 2 and press Enter. Use Backspace to remove the current setting,
then type in the VLAN ID or range. Press Enter to confirm the setting.
MD Level - This is the Maintenance Domain (MD) Level to match for responding to LBMs.
To change the Maintenance Domain (MD) Level, type 3 and press Enter. Use Backspace to remove
the current setting, then type in the new setting. Press Enter to confirm the setting.
Canoga Perkins Corp Ethernet Network Interface Device 22-SEP-2008
Model 9145E-101-2-0 V02.10 F121 02:59:35
---------------------------------VLAN LOOPBACK----------------------------------
1) 802.1AG Loopback Configuration
2) VLAN Loopback Statistics
3) L2 Ping Generator
Select [1-3]:
---------------------------------------------Messages----------------------------------------------
Canoga Perkins Corp Ethernet Network Interface Device 22-SEP-2008
Model 9145E-101-2-0 V02.10 F121 02:59:35
-------------------------802.1AG LOOPBACK CONFIGURATION------------------------
-
1) Administration State Enabled
2) VLAN ID (1-4094) 1-4094
3) MD Level (0-7) 0-7
4) Ether Type (4 Hex Digits) 8902
Select[1-4]:
---------------------------------------------Messages----------------------------------------------