Industrial Data Systems IDS 430 - Manual (Page 17)

IDS 430/433 Users Manual Version 1.0
- 17 -
Built In Application Programs
The following built in programs are available to enable:
1. Fill to Setpoint.
2. Checkweigh: Under/Between/Over.
3. Weigh-in / Weigh-out.
4. Axle Weigh/Container weighing – Short Scale.
5. Axle Weigh – Long Scale.
6. ID Tare and Total.
7. Peak Hold.
Use parameter function 73, “Initialize Function Memory”, to activate a built in
program. See section 7 (page 7-8) for more details.
The initialize function erases function memory and setpoint monitor memory, and
initializes all parameters that have a password level of 1 or 2. Use parameter
function 73 before configuring parameters with a password level of 1 or 2.