Industrial Data Systems IDS 430 - Manual (Page 19)

IDS 430/433 Users Manual Version 1.0
- 19 -
# 2 Checkweigh: Under/Between/Over
The indicator monitors the scale for activity, when the scale goes above the
‘empty’ weight, the indicator waits for a stable weight, and then outputs an
indication of Under, Between (OK), or over. The cycle resets when the scale
goes below the empty weight.
Installation
Connect TTL outputs to relays or lamp actuators.
Under weight indication TTL 1 TB4 - Pin 1
Between weight indication TTL 2 TB4 - Pin 2
Over weight indication TTL 3 TB4 - Pin 3
Ground GND TB4 - Pin 4
+ 5 volts DC +5v TB3 - Pin 1
Configure ‘empty’ scale weight. (Parameter 43)
Operators Functions
Enter setpoint weights
Press the F1 key. The display prompts “SP 1. Use the numeric keyboard to
enter setpoint 1, then press the ENTER key. The display prompts “SP 2”. Use
the numeric keyboard to enter setpoint 2, then press the ENTER key. NOTE:
use the F2 key to enter a decimal point if needed.
Recalculate
Press the F2 key to re-check the weight on the scale after adjustments have
been made to the weight.