KEYENCE DL-DN1 User Manual

Page 23

Advertising
background image

2-1 Installation and Connection to Sensor Amplifiers

2-5

2

C

onn

ec
tion
a

nd
C
onf

ig

u

ra

ti

o

n

- DeviceNet Compatible Network Unit DL-DN1 User’s Manual (GT2) -

3

Mount the supplied end units (OP-26751: a set of two pieces) on the outer
side faces of the amplifier and the DeviceNet compatible communication
unit, DL-DN1. Then, fix the end units with the screws on the top of each
end unit (2 points x 2 units). (Tightening torque: 0.6N
m or less)

Mount the end units in the same way as the DeviceNet compatible communica-
tion unit, DL-DN1.

Make sure that the sensor amplifier connector (for DIN rail mounting
type) is not askew on the side face of the DeviceNet compatible commu-
nication unit, DL-DN1, as shown below. If the connector is askew, the DL-
DN1 may become damaged when connected to the sensor amplifier.

Press the DeviceNet compatible communication unit DL-DN1 into full
engagement with the sensor amplifier. If the DL-DN1 is not correctly con-
nected, it may be damaged when the power is turned on.

NOTICE

Sensor amplifier connector

DeviceNet compatible
communication unit DL-DN1

End unit

End unit

NOTICE

Advertising