ALTANA Micro-Wave-Scan Manual - Manual (Page 54)

53
Appears when the number of measurements in
“Memory-Config Change” is set to a value less
than 1 or greater than 20. Repeat the setting with a
value between 1 and 20.
The specified year falls outside the valid range
from 2000 to 2100. Please repeat the input with a
valid year.
While adjusting the Display Time, you entered a
value outside the valid range from 15 - 99. Please
repeat the entry with a valid value.
Appears when the maximum number of
measurement series is reached for the selected
memory area.
The measurement was performed on a surface
with too low image forming qualities. Repeat the
measurement on a more suitable surface.
Appears when you have measured 100
checkzones with one memory area. Create a new
memory area and continue your measurements.
Error messages
Info and error messages