Attaching and removing the battery pack – Sharp VIEWCAM VL-WD650U User Manual
Page 25
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Attaching and Removing the
Battery Pack
Attaching the Battery Pack
1
Make sure that the Power switch is set
to OFF.
4
Lower the viewfinder.
2
Lift up the viewfinder.
Power source
mounting surface
Align the - mark on the side of the
battery pack with the ◄ mark on the
camcorder (®), and slide the battery
pack down completely until it locks into
place (®).
■D
fS
■g
Removing the Battery Pack
1
Perform steps 1 and 2 above.
2
Press the power source PUSH release
button (®), and slide the battery pack
up and take it out (®).
Power souroe PUSH
release button
Cautions:
• BEFORE REMOVINGTHE BATTERY PACK,
ALWAYS STOP RECORDING OR PLAYBACK
AND TURN THE POWER OFF.
Removing the
battery pack while shooting or during playback
may damage the tape by causing it to wrap
around the video head drum or may destroy the
SmartMedia card, rendering it unreadable and
unwritable.
• Remove the battery pack from the camcorder if
you will not use the camcorder for a long period
of time.
• Use only SHARP model BT-L221 or BT-L441
battery packs with this camcorder. Use of other
batteries may present a risk of fire or explosion.
10