Sharp VIEWCAM VL-WD650U - Manual (Page 71)

Windbreak
The windbreak function allows you to reduce
annoying noise from strong winds when
recording.
1
Set the camcorder to TAPE-CAMERA
mode.
2
Press the MENU/DISPLAY button until
the menu screen appears.
3
Select #, then press ►► on the Opera­
tion button. Select “WIND” (®), then
press ►► (®).
4
Press ■ or ►/ II to select “ON”, then
press
W I N D I on
5
Press the MENU/DISPLAY button to
turn off the menu screen.
To cancel Windbreak
Select “OFF” in step 4 above.
Note:
• Keep the windbreak function off during normal
recording. If it is left on, the recorded audio may
sound somewhat muffled when played back.
Setting the Confirmation
Sounds
A confirmation sound is made when you turn
on or off the Power switch, press the REC
START/STOP button, or perform other desig­
nated operations. Use the procedure below to
change the type of sound or to turn off the
confirmation sounds altogether.
Type of Confirmation Sound
Settings
CHIME: A chiming sound is made.
BEEP: An electronic beeping sound is made.
OFF: No confirmation sound is made.
1
Press the MENU/DISPLAY button until
the menu screen appears.
2
Select ETC, then press ►► on the
Operation button. Select “SOUND” (®),
then press ►► (®).
SOUND
t'l TIME CODE BEEP
TC OUT
DEMO MODE
\NGUAGE
OFF
3
Press ■ or ►/ II to select the desired
sound setting, then press
S O U N D I B E E P
g
<
s
O
s.
Tl
g
4
Press the MENU/DISPLAY button to
turn off the menu screen.
Note:
• If “OFF” is selected, the sound effect of a
camera shutter closing in PHOTO SHOT mode
and CARD-CAMERA mode will also be turned
off.
56