Sharp VIEWCAM VL-WD650U - Manual (Page 28)

Preparation
Installing the Lithium Memory
Battery
Installing the Lithium Battery
The supplied lithium battery is used to store the
memory of the date and time settings.
i 1
I
Press the LCD monitor OPEN release
button (®) and open the LCD monitor
(®).
® I ------ monitor OPEN
'‘‘‘ase button
Open the lithium battery compartment
door using the tip of a ballpoint pen or
other pointed object.
Insert the lithium battery into the
compartment with the + side facing out.
4
Replace the compartment door, and
close it firmly until it clicks into place.
5
Close the LCD monitor until it clicks into
place.
Removing the lithium battery
Perform steps 1 and 2 above.
Lift up the battery using a
pointed object, and take it out.
Note:
• Replace the battery with a new CR2025 lithium
battery when the time indicator of the camcorder
starts to fall behind the correct time.
Notes on the Use of the Lithium
battery
REPLACE BATTERY WITH TOSHIBA,
MATSUSHITA OR HITACHI MAXELL TYPE
CR2025 ONLY. USE OF A DIFFERENT
BATTERY MAY PRESENT A RISK OF FIRE OR
EXPLOSION.
iWJsMIlM KEEP THIS BATTERY AWAY FROM
CHILDREN. IF SWALLOWED, CONSULT A
PHYSICIAN IMMEDIATELY FOR EMERGENCY
TREATMENT.
■WaillWWi BATTERY MAY EXPLODE IF MIS­
USED OR INSTALLED WITH POLARITY
REVERSED. DO NOT RECHARGE, DISAS­
SEMBLE OR DISPOSE OF IN FIRE.
• Do not short-circuit, recharge, disassembie, or
heat the iithium battery.
• Shouid the lithium battery leak, wipe the battery
compartment clean, and then insert a new
battery.
• The lithium battery will last about one year under
normal usage.
13