Still recording effects, Type of still recording effects, Note – Sharp VIEWCAM VL-WD650U User Manual
Page 55: To cancel the still image in tapecamera mode, Notes
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
still Recording Effects
You can select one of these still recording
effects to record the still images with an effect.
Type of Still Recording Effects
PHOTO SHOT:
A still picture is recorded
following the sound and visual effects of a
camera shutter closing.
P-IN-P:
A still image is recorded within an inset
image displayed on a motion picture.
9 FRAMES:
A still picture is recorded at
intervals of 1/10 of a second using a 9-frame
picture.
16 FRAMES:
A still picture is recorded at
intervals of 1/10 of a second using a 16-frame
picture.
Selecting a still recording effect
1
Set the camcorder to TAPE-CAMERA or
CARD-CAMERA mode.
2
Press the MENU/DISPLAY button until
the menu screen appears.
3
Select (S, then press
Operation button.
on the
Note:
• In TAPE-CAMERA mode, select the
desired still recording mode (see page
39).
4
Press ■ or ►/II (®) to select “SNAP
EFR”, then press ►► (@).
1*1101«} SNAC
NAP F H-.
?? DGTL ZOOM
PHOTO SHOT
TAPE SPEED P-IN-P
'J 16:9
9 FRAMES
16 FRAMES
Using PHOTO SHOT, 9 FRAMES or
16 FRAMES mode
1
Perform the steps in “Selecting a still
recording effect” to select “PHOTO
SHOT”, “9 FRAMES” or “16 FRAMES”.
2
In Recording Standby
mode, press the STILL
button.
• In TAPE-CAMERA mode,
a still image of the subject
is displayed with the
selected effect. Perform step 3.
• In CARD-CAMERA mode, the still image
of the subject will be recorded with the
selected effect. Omit step 3.
Press the REC START/
STOP button.
• The still image of the subject
will be recorded on tape.
To cancel the still image in TAPE
CAMERA mode
In SNAP mode,
press the STILL button while
the camcorder is in Recording Standby
mode.
In STILL mode,
press the STILL button.
Notes:
• Still recording effects can also be used during
recording on tape by pressing the STILL button.
• If you use PHOTO SHOT during recording on
tape, the visual effects of a camera shutter
closing are recorded.
• You can use PHOTO SHOT without the sound
effect of a camera shutter closing by setting the
SOUND menu item to “OFF” (see page 56).
• The picture quality in Still Recording Effects
mode will be slightly lower than normal pictures.
$
E
5
Press ■ or ►/ II to select the desired
still recording effect, then press
.
I P H O T O S H O T
S N A P E F F .
6
Press the MENU/DISPLAY button to
turn off the menu screen.
40