Sharp VIEWCAM VL-WD650U - Manual (Page 34)

Preparation
Using the LCD Monitor
You can use the LCD monitor to play back
recordings that you have made. You can also
w/atch the subject on the LCD monitor \«hile
recording.
Press the LCD monitor OPEN release
button (®), and open the LCD monitor
to a 90° angle to the camcorder body
(®).
2
Adjust the LCD monitor to an angle that
allows easy viewing on the on-screen
picture.
• The LCD monitor rotates 270° vertically.
Note:
• You can also fold the LCD monitor into the
camcorder with the screen facing out for
watching playback on the monitor.
19
3
Hold down the Lock button
and set the Power switch to
CAMERA or VCR.
f
I*'
Lock button
Notes:
• Battery consumption is larger when the LCD
monitor is open. Use the viewfinder instead of
the LCD monitor when you want to save battery
power.
• Use the viewfinder if the LCD screen becomes
difficult to see in bright daylight.
Closing the LCD monitor
Return the LCD monitor to the vertical 90°
position with the screen facing in, and fold it
into the camcorder until it clicks into place.
Cautions:
• Do not use excessive force when moving the
LCD monitor.
• Do not try to rotate the LCD monitor verticaliy
until the monitor Is completely opened.
• When closing the LCD monitor, do not tilt it;
otherwise the monitor may not close properly
and may become damaged.
• Do not pick up the camcorder by the LCD
monitor.
• Do not expose the LCD monitor to shocks.
• Do not apply pressure to the LCD screen
surface.
• Do not place the camcorder with the LCD
screen facing down.
Notes:
• Take care not to touch the LCD screen with your
fingers, as perspiration and dirt will smudge it.
• Close the LCD monitor completely with the
screen facing in when not in use.
• Use a soft cloth to clean the LCD screen.