Toshiba 32HLX95 - Manual (Page 17)

Chapter 2: Connecting your TV
Connecting a VCR and Cable box
You will need:
► one signal splitter
► five coaxial cables
► two sets of standard A/V cables
• For better picture performance from your VCR: If your VCR has
S-video, connect an S-video cable [plus the audio cables] Instead
of the standard video cable. Do not connect an S-video cable and
a standard video cable to VIDEO I at the same time or the picture
performance will be unacceptable.
• If you have a mono VCR, connect L/MONO on the TV [VIDEO 1]
to your VCR's audio out terminal using the white audio cable only.
• When you use a Cable box, you may not be able to use the remote
control to program or access certain features on the TV.
Q To view basic Cable channels and use the TV’s features:
Select the ANT 1 video input source on the TV.* Use the
TV controls (top panel or remote control) to change
channels and access the TVs features.
D To view basic and premium Cable channels:
Turn OFF the VCR. Select the ANT 2 video input source
on the TV* Tune the TV to channel 3 or 4 (whichever
channel is vacant in your area). Use the Cable box controls
to change channels.
D To view the VCR:
Turn ON the VCR. Select the VIDEO 1 video input source
on the TV*
Note: A VIDEO 1 connection with an S-Video cable [instead
of a standard video cable) will provide better picture
performance [as mentioned in the first bulleted item at the
top of this page).
From Cable TV
' To select the video input source, press INPUT on the remote control
[see page 60]. To program the TV remote control to operate other
devices, see Chapter 3.
The unauthorized recording, use, distribution, or revision of television
programs, videotapes, DVDs, and other materials is prohibited under the
Copyright Laws of the United States and other countries, and may subject
you to civil and criminal liability.
Signal splitter IN Cable box
OUT OUT
CH3©
0H4U OUT
Note: The VIDEO/AUDIO OUT terminals output signals from the ANT I,
ANT2, VIDEO I, and VIDEO 2 terminals when the appropriate input mode
is selected. The playing disc’s contents by the DVD section are not output
□ To enable the TV Guide On Screen^^ system to work
with your cable box and to use the TV Guide
On Screen™ recording features:
1. Connect the G-LINK™ cable according to the
instructions on page 23.
2. Make sure the VCR is connected to the A/V OUT
terminals on the TV (see illustration).
3. Set the VCR to the appropriate line input (refer to your
VCR owners manual for details), and then turn OFF the
VCR.
4. See Chapter 5 for details on setting up the TV Guide
On Screen™ system.
5. See Chapter 7 for details on using the TV Guide
On Screen™ system.
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved. 17