Toshiba 32HLX95 - Manual (Page 19)

Chapter 2: Connecting your TV
Connecting a DVD player with ColorStream® (component video) and a VCR
Your TV has ColorStream® (component video) inputs.
You will need:
► one signal splitter
► three coaxial cables
► two sets of standard A/V cables
• For better picture performance, if your VCR has S~video, use an S-
video cable [plus the audio cables] instead of the standard video
cable. However, do not connect both types of video cable to
VIDEO 1 at the same time or the picture performance will be
unacceptable.
• If you have a mono VCR, connect L/MONO on the TV
[VIDEO i] to your VCR's audio out terminal using the white audio
cable only.
► one pair of standard audio cables
► one set of component video cables
• You can connect the component video cables [plus audio
cables] from the external DVD player to either set of
ColorStream HD terminals on the TV [HD 1 or HD 2]. The
ColorStream HD 1 and HD 2 terminals can be used with
Progressive [48Op, 720p] and Interlaced [480i, 1080i]scan
systems. A 1080i signal will provide the best picture
performance.
• If your DVD player has HD Ml video, see page 21.
Q To view antenna or Cable channels:
Turn OFF the VCR. Select the ANT 1 video input source
on the TV.*
D To view the DVD player:
Turn ON the DVD player. Select the ColorStream HD 1
video input source on the TV*
D To view the VCR:
Turn ON the VCR. Select the VIDEO 1 video input source
on the TV*
Q To record a TV program while watching a DVD:
Turn ON the VCR. Tune the VCR to the channel to
record. Select the ColorStream HD 1 video input source on
the TV* to view the DVD.
From antenna or Cable
' To select the video input source, press INPUT on the remote control
[see page 60]. To program the TV remote control to operate other
devices, see Chapter 3.
D To use the TV Guide On Screen™ recording features:
1. Connect the G-LINK™ cable according to the
instructions on page 23.
2. Make sure the VCR is connected to the A/V OUT
terminals on the TV (see illustration).
3. Set the VCR to the appropriate line input (refer to your VCR
owners manual for details), and then turn OFF the VCR.
4. See Chapter 5 for details on setting up the TV Guide
On Screen™ system.
Signal splitter IN Cable box
OUT OUT
C H 3 p
C H 4U OUT
DVD player with
component video
Note: The VIDEO/AUDIO OUT terminals output signals from the ANT 1, ANT2,
VIDEO 1, and VIDEO 2 terminals when the appropriate input mode Is selected.
The playing disc's contents by the DVD section are not output
5. See Chapter 7 for details on using the TV Guide
On Screen™ system.
The unauthorized recording, use, distribution, or revision of television
programs, videotapes, DVDs, and other materials is prohibited under the
Copyright Laws of the United States and other countries, and may subject
you to civil and criminal liability.
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved. 19