Toshiba 32HLX95 - Manual (Page 26)

Chapters: Using the remote control
Installing the remote control batteries
To iiistall the remote control batteries:
CAUTION: Always dispose of batteries in a designated disposal location. Never
throw batteries into a fire.
1. Slide the battery cover off the back of the remote control.
c
ZL
j
2. Install two “AA” size alkaline batteries. Match the + and - symbols on
the batteries to the symbols on the battery compartment.
hi© ©1
U|© ©r
______________ Y,
3. Slide the battery cover on to the remote control until the lock snaps.
Caution:
Never throw batteries into a fire.
Note:
• Be sure to use AA size batteries.
• Dispose of batteries in a designated disposal area.
• Batteries should always be disposed of with the
environment in mind. Always dispose of batteries In
accordance with applicable laws and regulations.
• if the remote control does not operate correctly or if the
operating range becomes reduced, replace batteries
with new ones.
• When necessary to replace batteries in the remote
control always replace both batteries-with new ones.
Never mix battery types or use new and used batteries in
combination.
• Always remove batteries from remote control if they are
dead or if the remote control is not to be used for an
extended period of time. This will prevent battery acid
from leaking into the battery compartment
Using the remote control MODE button to control your other devices
Your TV remote control has one dedicated TV mode and five programmable
multi-brand modes: CBL/SAT, VCR/PVR, DVD, AUDIO 1, and AUDI02. The
default device modes and programmable device modes are listed below.
Note: The TV remote control is preprogrammed to operate most Toshiba devices, if
you own a non-Toshiba device or a Toshiba device that the remote control is not
preprogrammed to operate, you will need to program the remote control See
“Programming the remote control to operate your other devices” on page 29.
MODE Default device mode control (before programming}
1)TV Toshiba TV
2) CBL/SAT Toshiba Satellite receiver
3) VCR/PVR Toshiba VCR
4) DVD Toshiba DVD
5) AUDIO 1 Pioneer Audio receiver
6) AUDI02 Pioneer LD
'XZ. 22TT-
©
0 © ( 3 )
Number [1-6]
MODE
MODE Device mode control after programming
1)TV Toshiba TV
2) CBL/SAT
Multi-brand video/audio devices
3) VCR/PVR
4) DVD
5) AUDIO 1
6) AUDI02
You can directly select the device mode by pressing the corresponding
number button (1-6) while pressing the MODE button.
Note:
Although your new TV’s remote control includes
codes for many devices, it may not include
codes for some or all of the features on certain
devices you wish to control If you are unable to
program the TV's remote control to operate
your device or some of the features on that
device, use the device’s remote control or the
controls on the device.
26 Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.