Toshiba 32HLX95 - Manual (Page 69)

Chapter 8: Using tìie TV’s features
Adjusting the picture
Selecting the picture mode
You can select your desired picture settings from four picture
modes, as described below.
To select the picture mode;
Press PIC MODE on the remote control
The following popup menu appears on-
® ® ®
® ® ®
screen.
PIC
MODE
Picture Settings
Repeatedly press PIC MODE to cycle
among the modes.
To select the picture mode using the menu system;
1. Press MENU and open the Video menu.
2. Highlight Picture Settings and press ENTER.
mtм М
® Advanced Picture Settings ;s
si Theater Settings
Picture Settings
iis Contrast
Brightness
ii Color
is Tint
iii Sharpness
100
50 ^
50 ■
0 '
50 ^
Mode Picture Quality
Sports Bright and dynamic picture [factory setting]
Standard Standard picture settings [factory setting]
Movie Lower contrast for darkened room [factory setting]
Preference Your personal preferences
3. Press T to highlight the Mode field, and then ^ ► to select
the mode you prefer.
Picture Settings
4. To save the new settings, highlight Done and press
ENTER. To revert back to the factory defaults, highlight
Reset and press ENTER.
Note:
• The picture mode you selected is for the current input
selection only [ANT 1 in the example above]. You can select
a different picture mode for each input selection.
• If you select one of the factory-set picture modes [Sports,
Standard, or Movie) and then change a picture quality setting
[for example, increase the contrast or change the color
temperature), the picture mode automatically changes to
Preference in the Picture Settings menu.
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.
Adjusting the picture quality
You can adjust the picture quality (contrast, brightness, color,
tint, and sharpness) to your personal preferences.
Seieotlon ◄ Pressing ►
Contrast lower higher
Brightness darker lighter
Color paler deeper
Tint reddish greenish
Sharpness softer sharper
To adjust the picture quality;
1. Press MENU and open the Video menu.
2. Highlight Picture Settings and press ENTER.
Û
v<n
I Advanced Picture Settings |
I theater Settings
Picture Settings
Mode
Contrast
Brightness
Color
Tint
Sharpness
Sports
50
50
0
50
3. Press AY to select the picture quality you want to adjust
(Contrast, Brightness, Color, Tint, or Sharpness), and then
to adjust the setting, as described in the table above.
4. To save the new settings, highlight Done and press
ENTER. To revert back to the factory defaults, highlight
Reset and press ENTER.
The picture qualities you adjusted are automatically saved in the
Preference mode (see “Selecting the picture mode,” above left).
69