Toshiba 32HLX95 - Manual (Page 61)

Chapter 8: Using the TV's features
wmmm
Labeling the video input sources
You can label each video input source according to the type of
device you connected to each source, from the following preset
list of labels:
— {default label)
Cable
DTV
Satellite/DSS
VCR
Laser Disk
DVD
Audio Receiver
Compact Disc
Video Recorder
Hide (to hide an unused input in the Input Selection
window)
Note:
If you set up a cable box in VIDEO /, that input will be labeled
automatically and cannot be relabeled until you remove the
device from the TV Guide On Screen™ setup.
To label the video input sources:
1. Press MENU and open the Preferences menu.
2. Highlight Input Labeling and press ENTER.
3. Press AT to highlight the video source you want to label.
is Favorite Channels
I Closed Caption Mode CG1
is Closed Caption Advanced
:ii Menu Language
Home CH Setup
C^) Navigate Select fililiin Back I9:m Exit
Input Labeling
Vi<l0O t
Video 2
ColorStream HD1
ColorStream HD2
HDMI
PC
ANT 2
Reset
Cable
Video Recorder
Hide
DTV
4. Press ^ ► to select the desired label for that input source. If
a particular input is not used, you can select “Hide” as the
label, which will cause that input to be “grayed out” in the
input list and skipped over when you press INPUT on the
remote control.
5. To save the new input labels, highlight Done and press
ENTER. To revert to the factory default labels, highlight
Reset and press ENTER.
Input labeling example:
The screen below left shows the default Input Selection screen
(with none of the inputs labeled). The screen below right is an
example of how you could label the inputs if you had connected
a VCR to VIDEO 1, Cable TV to VIDEO 2, a video recorder
to ColorStream HD 1 and a DTV set-top box to HDMI. Also
note that the ColorStream HD 2 input is labeled “Hidden,”
which means that the input will be skipped over when INPUT
or TV/VIDEO is pressed.
Input Selection ant i input Selection ant
i I
¡0
ANT 1
1®
ANT 1
O DVD o DVD
@ Video 1 © VCR
©
Video 2 © Cable
© ColorStream HD1 0 Video Recorder
© ColorStream HD2 ®
Ccio'S 'f-fe" •-'D2 {Hidden} ®
HDMI © DTV
©
PC
©
PC
© ANT 2 ® ANT 2
© - ©
/
to Select ® - ® / to Select
Input Selection screen
with no inputs labeled
To clear the input labels:
Input Selection screen with
all inputs labeled except input 5,
which has been hidden.
Press MENU and open the Preferences menu.
Highlight Input Labeling and press ENTER.
1.
2.
3. Highlight Reset and press ENTER.
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved. 61