HP LaserJet 4610n - Manual (Page 147)

Control panel message Description Recommended action
53.XY.ZZ CHECK RAM
DIMM SLOT X
An error occurred on some memory of
the printer.
Values of X, Y, and ZZ are:
X Device Location
1 Slot 1
2 Slot 2
Y Bank Number
1 Bank number 1
2 Bank number 2
3 Bank number 3
4 Bank number 4
ZZ Error Number
01 Unsupported memory
02 Unrecognized memory
03 Under minimum memory limit
04 Exceeded maximum memory limit
05 Failed RAM test
If prompted to do so, press to
continue. The printer should come to the
Ready state, but will not make full use of
all memory installed.
Otherwise:
1. Turn the printer off.
2. Verify that all DDR SDRAM meets
specifications and is correctly seated.
3. Turn the printer on.
4. If the problem persists, contact
HP Support at
http://www.hp.com/
support/clj4610 .
54.X PRINTER
ERROR
To continue
turn off then on
Printing cannot continue. There is a
toner remaining sensor malfunction.
Values of X are:
15 - Yellow
16 - Magenta
17 - Cyan
18 - Black
1. Turn the printer off and then back on.
2. If the problem persists, contact
HP Support at
http://www.hp.com/
support/clj4610 .
54.XX PRINTER
ERROR
To continue
turn off then on
01 - Printing cannot continue. The
humidity environmental sensor is
abnormal.
02 – Rotary motor abnormality.
05 – OHT sensor/media sensor.
06 – Density sensor.
1. Turn the printer off and then back on.
2. If the problem persists, contact
HP Support at
http://www.hp.com/
support/clj4610 .
55.0X.YY DC
CONTROLLER ERROR
For help press
alternates with
55.0X.YY
PRINTER ERROR
To continue
turn off then on
A printer command error has occurred.
X Description
00 – Communication error
01 – DC controller memory error
02 – Outgoing parity error
03 – No engine response
04 – Communication timeout
1. Turn the printer off and then back on.
2. If the problem persists, contact
HP Support at
http://www.hp.com/
support/clj4610 .
Control panel messages (continued)
ENWW Control panel messages 135