HP LaserJet 4610n - Manual (Page 86)

4. Press to highlight Tray <N> Type. (N represents the number of the tray you are
configuring.)
5. Press to select Tray <N> Type.
6. Press or to highlight the correct paper type.
7. Press to select the correct paper type.
A Setting saved message appears, and then the current type and size settings are
displayed.
Configuring Tray 2 for a custom paper size
The printer automatically detects many sizes of paper, but you can also configure trays for
custom paper sizes. You must specify the following parameters:
● Unit of measure (millimeters or inches)
● X dimension (the width of the page as it feeds into the printer)
● Y dimension (the length of the page as it feeds into the printer)
You must also move the tray’s CUSTOM/STANDARD switch to the CUSTOM position.
1 CUSTOM/STANDARD switch
2 Page width (X dimension)
3 Page length (Y dimension)
Use the following procedure to configure a tray for a custom size. Once a Custom size is set
for a tray, it will be retained until the switch in the tray is moved back to STANDARD.
To set a custom size in Tray 2
1. Open the tray and move the CUSTOM/STANDARD switch to the CUSTOM position.
Close the tray.
2. When the tray configuration message appears, press .
3. Press to change ANY CUSTOM to custom.
4. Press to select custom.
5. Press or to highlight the correct unit (either millimeters or inches).
6. Press to select the value.
After the unit of measure is set properly, set the X dimension as follows:
74 Chapter 4 Printing tasks ENWW