HP LaserJet 4610n - Manual (Page 165)

Control panel message Description Recommended action
REPLACE TRANSFER KIT
For help press
alternates with
REPLACE TRANSFER KIT
To continue press
The transfer unit is nearing the end of its
useful life and the SUPPLIES LOW
setting in SYSTEM SETUP is set to STOP. 1. Order the transfer kit.
2. To continue printing, press .
3. To replace the transfer kit, perform
the following steps:
● Open the top and front cover.
● Remove the old unit by
pressing the blue buttons on
either side of the unit.
● Slide the old unit out of the
printer.
● Install a new transfer unit.
● Close the front and top covers.
NOTE
If the old transfer unit was not at end-of-
life when it was replaced (for example, if
it was damaged), or if you want to
continue printing past the end-of-life
message, the transfer unit count must be
reset using the printer control panel.
Please note that the end-of-life message
is provided as a customer service, and
printing past it is likely to result in print
quality degradation in the near future.
Once the transfer kit count has been
reset after an end-of-life message,
feedback on the kit's remaining life will
be incorrect until the kit is replaced and
the count is reset again.
Control panel messages (continued)
ENWW Control panel messages 153