HP LaserJet 4610n - Manual (Page 150)

Control panel message Description Recommended action
68.X PERMANENT
STORAGE FULL
For help press
alternates with
68.X PERMANENT
STORAGE FULL
To continue press
A non-volatile storage device is full.
Pressing the button should clear the
message. Printing can continue, but
there may be unexpected behavior.
X Description
0 for onboard NVRAM
1 for removable disk (flash or hard)
1. Press to continue.
2. For 68.0 errors, turn the printer off
and then back on.
3. If a 68.0 error persists, contact
HP Support.
4. For 68.1 errors, use the HP Web
Jetadmin software to delete files
from the disk drive.
5. For 68.1 errors that persist, contact
HP Support.
68.X PERMANENT
STORAGE WRITE FAIL
To continue press
A non-volatile storage device is full.
Pressing the button should clear the
message. Printing can continue, but
there may be unexpected behavior.
X Description
0 for onboard NVRAM
1 for removable disk (flash or hard)
1. Press to continue.
2. If the message persists, turn the
printer off and then back on.
3. If the problem persists, contact
HP Support at
http://www.hp.com/
support/clj4610 .
68.X STORAGE ERROR
SETTINGS CHANGED
For help press
alternates with
68.X STORAGE ERROR
SETTINGS CHANGED
To continue press
One or more printer settings saved in the
non-volatile storage device is invalid and
has been reset to its factory default.
Pressing the button should clear the
message. Printing can continue, but
there may be unexpected behavior. 1. Press to continue.
2. If the message persists, turn the
printer off and then back on.
3. If the problem persists, contact
HP Support at
http://www.hp.com/
support/clj4610 .
79.XXXX
PRINTER ERROR
To continue
turn off then on
A critical hardware error has occurred. 1. Turn the printer off and then back on.
2. If the problem persists, contact
HP Support at
http://www.hp.com/
support/clj4610 .
8X.YYYY
EIO X ERROR
The EIO accessory card in slot X has
encountered a critical error.
X Description
1: error in slot 1
2: error in slot 2
1. Turn the printer off and then back on.
2. If the problem persists, contact
HP Support at
http://www.hp.com/
support/clj4610 .
Access Denied
MENUS LOCKED
An attempt has been made to modify a
menu item while the control panel
security mechanism is enabled by the
printer administrator. The message will
disappear shortly, and the printer will
return to Ready or BUSY state. Contact the printer administrator to
change settings.
Calibrating... The printer is calibrating. No action necessary.
Control panel messages (continued)
138 Chapter 8 Problem solving ENWW