HP LaserJet 4610n User Manual
Page 211
Advertising
4. Using a #2 Phillips screwdriver, remove the eight screws holding the board in place, and
set them aside.
5. Slide out the formatter board and set it on a clean, flat, grounded surface.
6. Align the groove on the side of the flash memory card with the notches in the connector
and push it in the slot until it is fully seated.
*2
P1
28
SE
03
76
*
*2
P1
28
SE
03
76
*
*2P128SE0376*
*2P128SE0376*
CAUTION
Do not insert the flash memory card at an angle.
NOTE
The flash memory slot marked "Firmware Slot" is reserved for firmware only.
ENWW
Installing memory
199
Advertising