HP LaserJet 4610n - Manual (Page 160)

Control panel message Description Recommended action
REMOVE ALL
PRINT CARTRIDGES
To exit press STOP KEY
The printer is executing a Component
Test and the component selected is Belt
Only. Remove all print cartridges.
Remove at least one
print cartridge.
To exit press STOP KEY
The printer is executing a Disable
Cartridge Check or Component Test
where the component selected is
Cartridge Motor. Remove one print cartridge.
REPLACE <COLOR>
CARTRIDGE
The supplies gauge will display the
consumption levels of print
cartridges.
alternates with
For help press
The supplies gauge will display the
consumption levels of print
cartridges.
The identified print cartridge has
reached the end of life and the COLOR
SUPPLY OUT setting in SYSTEM
SETUP is set to STOP. Printing will not
continue until the cartridge is replaced. 1. Open the top cover and image
transfer unit.
CAUTION
The image transfer unit can be easily
damaged.
2. Remove the identified print cartridge.
3. Install a new print cartridge.
4. Close the top and front covers.
REPLACE <COLOR>
CARTRIDGE
The supplies gauge will display the
consumption levels of print
cartridges.
alternates with
To continue press
The supplies gauge will display the
consumption levels of print
cartridges.
The identified print cartridge is nearing
the end of its useful life and the
SUPPLIES LOW setting in SYSTEM
SETUP is set to STOP. 1. Order the identified print cartridge.
2. To continue printing, press .
3. To replace the cartridge, perform
the following steps:
● Open the top cover and image
transfer unit.
CAUTION
The image transfer unit can be
easily damaged.
● Remove the identified print
cartridge.
● Install a new print cartridge.
● Close the top and front covers.
Control panel messages (continued)
148 Chapter 8 Problem solving ENWW