HP LaserJet 4610n User Manual
Page 169
Control panel message
Description
Recommended action
TRAY XX SIZE= <SIZE>
Verify tray switch set to CUSTOM
alternates with
TRAY XX SIZE= <SIZE>
then close tray
A non-detectable media size was
selected from the menu and the tray is
open.
The selected size requires that the tray
switch be set to CUSTOM, otherwise
when the tray is closed, the tray size will
change.
1.
Adjust the side and rear media
guides against the paper.
2.
If the media used is letter, A4,
executive, JIS B5, A5, or legal, the
tray switch should be set to
STANDARD. Set the tray switch to
CUSTOM for all other media sizes.
The tray switch must be set before
the size can be selected from the
control panel.
3.
Close the tray.
TYPE MISMATCH
TRAY XX=[TYPE]
For help press
alternates with
Ready
The media type loaded in the tray does
not match the media type configured for
the tray.
1.
Adjust the side and rear guides
against the paper.
2.
If size is a detectable size, set the
tray switch to STANDARD,
otherwise set the tray switch to
CUSTOM.
3.
If necessary, press after the tray
is closed to change the paper size
or type.
Unable to mopy job
alternates with
Processing...
A Mopy job cannot be mopied because
of a memory, disk, or configuration
problem. Only one copy will be produced.
Install additional memory in the printer.
Unable to Store Job
alternates with
Processing...
A job cannot be stored because of a
memory or configuration problem.
Install additional memory in the printer.
USE TRAY XX
[TYPE] [SIZE]
To change press /
To use press
The printer is offering a selection of
alternate media to use for the print job.
1.
View tray configurations (type and
size) using and .
2.
Press to select a tray to use.
Wait for printer
to reinitialize
RAM disk settings have been changed
before the printer automatically restarts,
or external device modes have changed
or the printer is coming out of the
diagnostics mode and will automatically
restart.
No action necessary.
Warming up
The printer is coming out of PowerSave
mode. Printing will continue as soon as
warmup is completed.
No action necessary.
Control panel messages (continued)
ENWW
Control panel messages
157