Ecler ECLERNET MANAGER - Manual (Page 152)

152
The aspect of the OUTPUTS section of the MIMO88CONF for outputs 5 to 8 and 9 to 16 is as follows:
This image shows the following differences compared to the output groups 1 to 4 and 9 to 12:
 An output signal should be selected in the list (OUT1 to OUT4 and OUT9 to OUT12)
 No processing except the DELAY setting, especially useful when using these outputs to deliver a
signal to a sound reinforcement system located at some distance from the main speakers, and to
time-align the main speakers and the reinforcement speakers
8.6. DUCKERS Section
The aspect of the DUCKERS section of the MIMO88CONF is as follows:
The differences compared to the standard version are:
 No PAGER modules (so this version is not compatible with the MPAGE16 paging station)
 One single DUCKER module for handling signals with highest priority (emergency or evacuation
messages, etc.). The module can act directly on the 4 or 8 outputs with full mixing functionality (1
to 4 / 9 to 12). If one of them is selected as sound source for any of the outputs 5 to 8 or 13 to 16,
the DUCKER will also act on the destination output(s).