Ecler ECLERNET MANAGER User Manual

Page 99

Advertising
background image

99


The wheel controls by default the volume (Volume mode) allocated with the programming. In addition, it
may act as a selector (Selection mode) for the sound sources associated with a particular zone, or as a
Preset selector. To switch from Volume mode to Selection mode, you must press T2, turn the control
wheel to make the desired change and press T2 again to confirm. A triangular index to the right of the
LCD screen indicates whether the unit is in Volume adjustment mode (pointing the bottom row of
characters) or Selection mode (pointing the top row of characters).

When selecting a WPTOUCH unit in the REMOTE LIST, its detailed configuration screen is displayed on
its right:


In its upper part, the display includes:

Enable/Disable Remote button: to enable (lit in green) or disable each WPTOUCH unit connected

to the MIMO88. The state (enabled or disabled) of remote controls is stored in a system Preset
when you save it, so that you can manage which remote controls are enabled or not by recalling
each Preset (e.g. when loading a Preset for asking to evacuate a building with a pre-recorded
message, all remote controls of the installation are disabled to avoid user interferences in such
special scenario in which the evacuation message prevails on the rest of the audio signals...).

HID indicator: hardware ID (assigned at the factory, unique to each unit and not editable by the

user)

Firmware indicator: unit's firmware version


Now comes the WPTOUCH configuration area:

 The (Change Configuration) icon gives access to the configuration parameters of the unit
 The (Save Configuration in Remote) icon stores the WPTOUCH device configuration

Clicking on the

icon opens the WPTOUCH configuration window:

Advertising