FingerTec R2 Manual - Manual (Page 28)

28 CONTENTS
To configure Access Combo: press Menu > Options > Access Options > Access Comb
> Select the combination you want for example Comb1 > OK > input the number, in
this case 123 to represent GRP TP1, GRP TP2, GRP TP3> OK
Lock
The opening period of the electromagnetic lock or door bolt can be controlled ac-
cording to your requirement or preference. The default value is 150 which translates
to 3 sec. 50 is equivalent to 1 second. Press Menu > Options > Access Options > Lock
> Determine the value of lock delay.
Door Sensor Delay
Door sensor delay can be configured to alert users if a door is not closing well after
a time period. A door sensor must be installed prior to activation of this option. The
default period is 10seconds and the maximum period is 999seconds. Press Menu >
Options > Access Options >Dsen Delay > Determine the value of lock delay.
Door Sensor Mode
Door sensor mode is to configure the time to alert an internal buzzer if the door is not
closing properly. The standard of door locking system includes:
Normally Closed (NC): An electrical contact that regularly allows electricity to flow
until it is signaled to open
Normally Open (NO).: An electrical contact that rarely allows electricity to flow. To
use door sensor, select NC. Press Menu > Options > Access Options > Dsen Mode >
Determine the type correctly > OK
Door Sensor Alarm
Door Sensor Alarm can be configured to alert users by using the alarm system if a door
is not closing well after a time period. An alarm system must be installed first to use
this operation. Press Menu > Options > Access Options > Dsen Alarm > Determine
the period > OK
Turning Off Alarm
There are scenarios that require you to turn off your alarm system and this can be
done through the terminal. To do this you have to press and hold the security button
at the back of the terminal followed by pressing Menu > Turn Off Alarm.If you didn’t
press the security button, the message “System Broken!!!” message will be displayed
when you press the Turn Off Alarm operation button.
Duress Options
The terminal will trigger an alarm system after receiving a successful verification from
a duress password.