FingerTec TA200 Plus Manual - Manual (Page 11)

12 CONTENTS
 • USER
Enrolling User
The FingerTec terminals can enroll fingerprint templates, passwords and card informa-
tion. This chapter covers all possible user enrollments in the terminals.
FINgerPrINt eNrollmeNt
It is recommended to enroll two fingers for one user ID. One template is the default
and another one is used for backup. You need to check the quality of the fingerprint
before doing any fingerprint enrollment. It is important to locate the center points of
the finger because the center points has to be placed in the middle of the scanner dur-
ing enrollment to get a good reading. You also have to make sure that the fingers are
not too wet or too dry for enrollment. To enroll fingerprint: Press Menu > User Mgmt
icon > New User > ID. No: (insert value) > Select “Enroll FP” > Select Privilege > Place
your fingerprint  times following instructions given by the terminal > OK to save.
CArd eNrollmeNt
For terminals that are using card system, default card for the terminal is RFID. MiFare
and HID card systems are available upon request. To enroll card: Press Menu > User
Mgmt icon > New User > ID No: > Insert User ID > Select “Enroll Card” > Wave the card
at the scanning area until the screen displays the Card ID > OK to save.
PASSword eNrollmeNt
The terminal offers different enrolment methods, and passwords can be used alone or
in combination with other verification methods. The maximum length of a password is
8 digits. To enroll password: Press Menu > User Mgmt icon > New User > ID No: (insert
value) > Select “Enroll Pwd” > Input password using the keypad > Reconfirm password
> OK > OK to save.
Verifying User
1:1 (oNe to oNe) / 1:N (oNe to mANy)
VerIFICAtIoN method ProCeSS
1:1 (One to One) You have to identify your User ID before inputting any biometrics
feature for verification. For example, your user ID is 1008. One to
one method requires you to key in user ID followed by your finger-
print to get verified.
1:N (One to Many) You don’t need to identify your User ID before inputting any bio-
metrics feature for verification. Simply place your finger on the
scanner for verification.