FingerTec AC100 - Manual (Page 16)

17 CONTENTS
4 • USER
Enrolling User
The terminals can enroll fingerprint templates, passwords and card information. This
chapter covers all possible user enrollments in the terminals.
Caution: Enrollment of supervisor or administrator is important to making sure of the
terminals data safety. Prior to enrolling new user, supervisor has to be enrolled first by
using any of methods mentioned below. Select Enroll Admin > Choose the Privilege
Level either Supervisor or Administrator to proceed.
FiNgerpriNT eNrollmeNT
(This feature is NOT available in TimeLine 100 model.)
It is recommended to enroll two fingers for one user ID. One template is default and
another one is used for backup. You need to check the quality of the fingerprint be-
fore doing any fingerprint enrollment. It is important to locate the center points of the
finger because the center points has to be placed in the middle of the scanner during
enrollment to get a good reading. Refer to page 17. You also have to make sure that
the fingers are not too wet or too dry for enrollment.
Enrolling fingerprint: Press Menu > User Manage > Enroll User > Enroll FP > New Enroll
> OK > Place finger 3 times > (OK) Save > ESC to exit, New Enrol (Continue?) – OK to
proceed to enroll another fingerprint.
Enrolling backup fingerprint: Press Menu > User Manage > Enroll User > Enroll FP >
ESC > Input User ID > Place finger 3 times > (OK) Save > ESC to exit, New Enroll (Con-
tinue?) – OK to proceed to enroll another fingerprint.
CArd eNrollmeNT
The default card for the terminal with card reading feature is the RFID card. MiFare and
HID card systems are available upon request.
Enrolling card: Press Menu > User Manage > Enroll User > Reg RFID > New Enroll? >
OK > Key in User ID (PIN) > Wave the card at the scanning area until the screen displays
the Card ID > (OK) Save
pASSWord eNrollmeNT
The terminals offer password verification and maximum length of password is 5 digit.
Enrolling password: Press Menu > User Manage > Enroll User > Enroll Pwd > New En-
roll? > OK > Key in User ID (PIN) > OK > Input your password > LCD showing the ID with
minus -P to indicate that the user ID is using password > OK (Save)
Changing password: Press Menu > User Manage > Enroll User > Enroll Pwd > ESC >
Input User ID > OK > Change your password > LCD showing the ID with minus -P to
indicate that the user ID is using password > OK (Save)