FingerTec TimeLine 100 Manual - Manual (Page 9)

9
1 8
TOP
FRONT
1 8
JOINT 1 PIN JOINT 2 PIN
TX+ 1
• •
3 RX+
TX- 2
• •
6 RX-
RX+ 3
• •
1 TX+
RX- 6
• •
2 TX-
CONNECTOR PIN CABLE COLOR CONNECTOR
TX+ 1 • White/Orange • 1 TX+
TX- 2 • Orange • 2 TX-
RX+ 3 • White/Green • 3 RX+
4 • Blue • 4
5 • White/Blue • 5
RX- 6 • Green • 6 RX-
7 • White/Brown • 7
8 • Brown • 8
TCP/IP PORT
POWER ADAPTER
PORT
RS484 PORT
2. RS485 Network Connection
1. RS485 Single Connection
RX+
RX-
RS232/ RS485
Data Converter
RX+
RX-
RS232/ RS485
Data Converter
RS232 PORT
RS232/RS485 SERIAL
CABLE PORT
USB PORT
CONTENTS
Communications
Connection points for power and communication are available on top of the terminals.
Refer to the following diagrams for the terminals you require.
USB PORT
Linking with USB flash disk for remote data transfer.
TCP/IP PORT
Connect with CAT 5 cable for LAN connection, one end to this port
and another end to the computer’s TCP/IP Port.
TCP/IP for Single Connection – Linking the terminal to a single computer
using TCP/IP requires Ethernet 10/100Base-T Crossover Cable. The cable can be
used to cascade hubs or to connect Ethernet stations back-to-back without a
hub. It works with both 10Base-T and 100Base-TX.
TCP/IP for Network Connection – Linking
the terminals to multiple computers using TCP/IP
requires Ethernet 10/100Base-T Straight Thru Ca-
ble or “whips”. The cable works with both 10Base-
T and 100Base-TX, connecting a network interface
card to a hub or network outlet.