FingerTec Kadex Manual - Manual (Page 28)

28 CONTENTS
11 • AUTO TEST
Who should do the Auto Test?
Auto Test page is to diagnose or analyze the conditions in the terminal. There are 6 tests
available in the Auto Test page and only the administrator is allowed to perform the
test. Before running any tests, kindly contact your reseller for advice or you could email
[email protected] .
Run All Tests At Once
The Auto Test contains 6 tests and to run all of them at once, Press Menu > Options >
Auto Test > Run All Test > OK > “Pls keep Pwr On” message will be displayed > The ter-
minal will run all tests and when finished the LCD will display the result such as this: All:
31 Bad: 0, to indicate the level of breakdown in the terminal.
FLASH Test
Press Menu > Options > Auto Test > FLASH test > OK > “Pls keep Pwr On” message will
be displayed > The terminal will run all tests and when finished the LCD will display the
result such as this: All: 31 Bad: 0
LCD Test
Press Menu > Options > Auto Test > LCD test > OK > The screen will display lines of ‘W’.
Any missing Ws or jagged W indicates LCD error. Escape to return to the previous page
Voice Test
Press Menu > Options > Auto Test > Voice test > OK > The LCD will display for example:
“Play Voice 1” and you will hear the message for that. Press OK to listen to the next voice.
Any error indictes that something is wrong with the speaker.
Key Test
Press Menu > Options > Auto Test > Key Test > OK > Press any key and look at the LCD
display. If the key matches the description on the LCD, the keypad is in good condition
RTC Test
Press Menu > Options > Auto Test > RTC test > OK > If the RTC battery is still working,
the test will prompt an “OK!”