FingerTec AdapTec Plus (New Model) - Manual (Page 4)

5
3
1
4
2
1 2 3 4 5 6
UNDERSTANDING THE DESIGN
AdapTec Plus consists of 2 main modules
1 Power supply/power input module 3 Door lock timer
2 Power output/access control module 4 LED status indicator
Power supply/power input module
1 This portion is to be connected to a power source with AC110~240V. An AC
current should be supplied into this side and a 12VDC 3A current will be gen-
erated as output.
2 These two cables, -V and +V are default and are connected to the inner part
of AdapTec. Please do not remove or change these cables.
Power output/access control module
3 These cables connect to the 12VDC power from the power supply/input
module. Do not remove or dismantle these cables.
4 These cables connect to a 12VDC rechargeable backup battery. During a
power failure, the backup battery will power up AdapTec Plus.
5 These are the power output ports from AdapTec Plus. Refer to the wiring
diagram for details.
6 These are the Wiegand data input ports from the FingerTec terminals. Refer
to the wiring diagram for details.