Flintec FT-15D User Manual
Page 15
FT-15(D) Technical Manual, Rev. 1.02 August 2010
Page 15 of 52
First weighing cycle without printing first weighing label (parameter 045=0):
Steps
Vehicle
Position
Description
There is no vehicle
on the weighbridge.
(Unloaded Scale)
If the indication is not 0 kg, press the
<Zero> key before loading the scale in the
instrument ready status.
[
0
kg ]
Vehicle is parked on
the scale and the
engine is stopped.
Load the scale.
[
9760
kg ]
Press the <First> key to start the first
weighing cycle.
[ First ]
Message will be displayed for 1 second.
[ V. Id ]
[
584
]
Enter a vehicle ID number numerically (up
to 6 digits) as a first weighing code.
Press the <Enter> key.
[ Id1 ]
[
78
]
Press the <M> key to select from the ID
memory or press the <ID> key for a
numeric entry, if this entry is defined for the
first weighing (refer to parameter [043]).
Press the <Enter> key.
[ Id2 ]
[
22
]
Press the <M> key to select from the ID
memory or press the <ID> key for a
numeric entry, if this entry is defined for first
weighing. (refer to parameter [044]).
Press the <Enter> key.
[Save W ]
[
9760
kg ]
If the vehicle has finalized the weighing
process, press the <Enter> key to save the
weighing result.
[ Unload ]
[
9760
kg ]
Vehicle is on the
scale + the displayed
weight is stable.
Message appears until the scale gets
unloaded.
[
0
kg]
Vehicle leaves the
scale.
Unload the scale.
If the displayed weight is less than 20e or
the <F> key is pressed, FT-15 returns to
the instrument ready status.
Press the <F> key to cancel the first weighing cycle.
If the vehicle ID already exist in the first memory the [Change ] message will be displayed.
Go to the temporary first weighing memory to delete the first weighing record.
[Code FL]
message appears, if the temporary first weighing memory is full. Check the memory for records
which can be deleted or wait until any second weighing cycle to free memory for a new 1
st
weighing.