GTCO AccuTab II - Users Guide - Manual (Page 26)

AccuTab II 26
Did the software work in the past?
If the software package worked with the tablet in the past, then the problem lies with the
new set up.
 Check all the connectors. Is the tablet still plugged into the same port? If yes, reset
the tablet by unplugging and re-plugging the power supply and restart the software.
 Did you reset or power down the computer?
 During reset and power on, the computer can send meaningless characters out the
serial port and this can disable the tablet. Reset the tablet again.
 Have you installed any new software or hardware? Remove it from your system and
see if the problem goes away.
 Did you move any cables?
 If you are using a PC, did the new software alter your AUTOEXEC.BAT file?
 Have you updated the software or its drivers?
 Are you loading another mouse driver?
 Did you reinstall the software, perhaps after a problem with your hard drive?
Double check your installation procedure and the driver you selected.
 Reinstall the software from its master diskettes. The program files may have been
corrupted.