GTCO AccuTab II - Users Guide - Manual (Page 4)

AccuTab II 4
Parts Checklist
 AccuTab II Series digitizing tablet with attached Controller
 Power supply
 Transducer (cursor or stylus)
 Computer interface cable with 9-pin connector
 TabletWorks CD
NOTE: AccuTab II Controller is the small enclosure attached to the back of the tablet that
contains the electronics that drive the digitizer.
What You Will Need to Use AccuTab II
 Computer with an RS-232C communication port
 Graphic application software that accepts digitizer input
Care and Handling
Cleaning AccuTab II
 To clean the tablet, GTCO CalComp by Turning Technologies recommends using any
non-abrasive cleaner that is appropriate for cleaning kitchen counter tops.
 To clean the cursor body, use a mild cleanser. Do not spray the cleanser directly on
the cursor, instead dampen a soft cloth with a mixture of water and the cleanser.
 Clean cursor reticles with alcohol.
NOTE: Excessive cleaning can dissolve the filled black cross hair on a reticle.
Maintaining the Transducers
Replacing the Pen Tip
To replace the pen tip, grasp the tip and pull
straight out (see figure). Insert the new tip
and press until it clicks into place.