GTCO AccuTab II - Users Guide User Manual
Page 7
Advertising
AccuTab II 7
to virtually any pedestal. Contact GTCO CalComp by Turning Technologies at
1.866.746.3015 or email us at
NOTE: Do not drill holes in any GTCO CalComp by Turning Technologies tablet.
Connecting to Your Computer
GTCO CalComp by Turning Technologies provides an RS-232C/power supply cable with
each AccuTab II system.
Connect the round end of the serial
cable to the jack labeled I/O on the
Controller. The arrow on the
connector should face up.
Attach the 9-pin or 9-pin to 25-pin
connector to the serial port on back
of computer.
Connecting the Power Supply
Attach the power supply’s cable to
the jack on the back of the serial
cable’s connector. Plug the power
supply into a power outlet or power
strip.
Advertising