GTCO AccuTab II - Users Guide - Manual (Page 39)

AccuTab II 39
CalComp Emulation Commands
AccuTab II recognizes a subset of the CalComp 9500 command set. Space does not permit
a detailed description of CalComp commands. However, most of the commands in this
subset have equivalent AccuTab II commands. For further information about the operation
of those commands, please refer to the AccuTab II command or function description in the
GTCO CalComp by Turning Technologies AccuTab II Command Summary.
NOTE: CalComp commands must be terminated with a <CR>, which is not shown in the
codes listed here. Commands can be strung together by substituting an @ character for
the <ESC>% sequence after the first command and postponing the <CR> until the end of
the multiple command string.
Disable/Enable Echo
Code: ESC%En
Where n=0 to 3 (0 and 2 disable echo, 1 and 3 enable echo). If n is not included in the
command, echo is toggled on or off from its previous state.
(Equivalent to Enable Echo Mode, EM and Disable Echo Mode, hex 0F.)