I.C.E. HTDM Food Process Unit - Manual (Page 38)

38
Terminal Connect to
J2-1 Feedback from actuator
(0-10VDC)
J2-2 Not used
J2-3 Black wire from
discharge
J2-4 Red wire from discharge
J2-5 White wire from
discharge
J2-6 *Black wire from
tachometer
J2-7 *Brown wire from
tachometer
J2-8 *Blue wire from
tachometer
Option 1
*Note: If equipped with a discharge sensor with red, white and
black wire leads see option 2.
Terminal Connect to
J2-1 Feedback from actuator
(0-10VDC)
J2-2 Not used
J2-3 Black wire from
discharge
J2-4 Red wire from discharge
J2-5 White wire from
discharge
J2-6 White wire from
tachometer
J2-7 Red wire from tachometer
J2-8 Black wire from
tachometer
Option 2
9. Remove the end connector of the 8 pin connector and expose the
individual wires(approximately 3 inches).