Interlogix TVK-800 - Manual (Page 58)

56 TVK-800 User Manual
Note: If you enter 0 + MON in live view mode, multiview mode is not supported
as video is then displayed on the keypad.
Display a specific camera on a monitor
You can select which camera to display on a monitor.
To display a specific camera on a monitor:
1. Press the Num + MON keys to select the monitor.
2. Press the Num + WIN keys to select the video tile to be displayed on the monitor
 Or 
Directly touch the keypad window to select the desired video tile.
3. Press the Num + CAM keys to select the camera.
For example, press 1+MON, 2+WIN, 3+CAM to decode the video signal from
Camera 3 and display it on Video tile 2 of Monitor 1.
Set up a camera group to display on a monitor
You can use a decoder to configure the keypad to display the images from a camera
group on a monitor.
When the number of cameras in a group is less than or equal to the number of video
tiles on-screen (for example three cameras and four video tiles), each camera is then
displayed on its corresponding time (for example, camera 1 on video tile 1, camera 2 on
video tile 2…)
When the number of cameras in a group is more than the number of video tiles on-
screen (for example 16 cameras and 4 video tiles), the cameras are displayed in the
following sequence mode: cameras 1 to 4 are displayed on video tiles 1 to 4, next
cameras 5 to 8 on video tiles 1 to 4, cameras 9 and 12 are displayed on video tiles 1 to
4, and finally cameras 13 to 16 on video tiles 1 to 4.
Note: The default dwell time is 30 seconds.
An error message will appear in the Hint box of the shortcut screen when an invalid
action is entered.