Interlogix TVK-800 - Manual (Page 68)

66 TVK-800 User Manual
Setting a preset tour
Preset tours move a PTZ dome camera to a sequence of steps. The camera stays at a
step for a set dwell time before moving on to the next step. A step consists of a step
number, a dwell time, and a speed.
The step number is the order the camera will follow while cycling through the preset
tour. The dwell time is the length of time that a camera stays at a step before moving to
the next step. The speed is the rate at which the camera will move from one step to the
next.
A preset tour requires at least two presets.
The PTZ dome camera must be able to support preset tours.
An error message will appear in the Hint box of the shortcut screen when an invalid
action is entered.
There are two ways to set a preset tour:
Method 1: To set a preset tour using an output channel
1. Press the Num + MON keys and select the monitor.
2. Press the Num + WIN keys and select the video tile.
3. Press the SET key to enter the Settings window.
4. Press the Num + PATROL keys to enter the “Preset Tour Settings” window.
5. Enter the preset number and press ENTER , enter the dwell time (called “Stop
Time on-screen) and press ENTER , and then enter the speed and press ENTER .
6. To set the next preset in the tour, repeat step 5.
Note: To clear all programmed parameters, press the Num + PATROL keys
again.
7. Press the SET key again to complete the preset tour.
Method 2: To set a preset tour using an input channel
1. Press the Num + CAM keys to select the camera.
Note: The action 0 + CAM is invalid.
2. Press the SET key to enter the Settings window.
3. Press the Num + PATROL keys to enter the Preset Tour Settings window.