Interlogix Concord 4 User Manual - Manual (Page 27)

Concord 4 User Manual 25
To delete a user code:
1. Enter the programming menus by pressing 9, system or partition master
code.
2. For Concord 4 systems, press 030 nnn 0, where nnn is the user number (000
to 229). For Concord Express V4 systems, press 030 nn 0, where nn is the
user number (00 to 15).
3. Enter the system or partition master code, and then press #.
4. Press *, 00, # to exit the programming menus.
When a code is deleted, it can no longer operate the system.
Assigning code attributes
Code attributes determine the limits or capabilities of a code. You will want
certain users to have more control over the system than others. For example,
you would want an adult to have more control over the system than a child. This
section describes code attributes that you can assign.
Direct bypassing attribute
This attribute allows the user to bypass open sensors. If the user code does not
have this attribute turned on, the code restricts the user from bypassing sensors
directly. To assign direct bypassing to a user:
1. Enter the programming menus by pressing 9, system or partition master
code.
2. For Concord 4 systems, press 030 nnn 1, where nnn is the user number (000
to 229). For Concord Express V4 systems, press 030 nn 1, where nn is the
user number (00 to 15).
3. To turn direct bypassing on, press 2, #. To turn direct bypassing off, press 1,
#.
4. Press *, 00, # to exit the programming menus.
Remote access attribute
This attribute allows the user to access the security system from a telephone
outside the protected premises. If the user code does not have this attribute
turned on, the code restricts the user from remote telephone access. To assign
remote access to a user:
1. Enter the programming menus by pressing 9, system or partition master
code.